Pumps & Compressors

 entries per page 
20
 1 - 18 / 18 
Test pump MPP 70-35
new
Fully automatic test pump for carrying out water pressure tests,
e.g. according to DVGW W 400-2, ÖVGW W 101, EN 805
- max. outlet pressure 35 bar
- delivery volume 70 l/min.
- Voltage 400 volt - 50 Hz
- Power consumption 5.5 kW
- Test pressure adjustable in 0.1 bar steps
- Frequency converter and speed control for adapted pressure build-up
and pressure maintenance without pressure surges
- freely adjustable, constant speed via "manual operation
- check valve for locking the pressure line
- Storz connection and quick couplings for water inlet and water outlet
- optionally with flow measurement (necessary for air volume determination in smart memo)
- optional with disinfection procedure for MPP
- optional with wheel set

Suitable for pressure build-up in large pipeline volumes. For small pipeline volumes with V < 1m^3, the MPP 70-35 is only suitable to a limited extent, as the test pressure may be "overrun".Test pump MPP 30-30
Fully automatic test pump for simplified execution of water pressure tests according to DVGW W 400-2, ÖVGW W 101, EN 805
- max. outlet pressure 30 bar
- delivery volume 30 liter/min.
- power supply 230 Volt / 400 Volt - 50 Hz
- power consumption 2,2 kW
- test pressure adjustable in 0,1 bar steps
- frequency converter and speed control for adapted pressure build-up and pressure maintenance without pressure surges
- freely adjustable, constant speed via "manual operation"
- non-return valve for blocking of pressure line
- Storz coupling and quick-coupling for water inlet and outlet
- optional with volume flow measurement (necessary for air volume determination in smart memo)
- optional disinfection procedure for pump
- optional with wheel set
Test pump MPP 11
Test pump MPP 11 Pressure range 0 - 25 bar
full automatic testing pump for pressure build-up and pressure holding adjusted
without pressure impulses

technical data:
- connection value: 230 V   50 Hz
- power consumption: 1.850 VA
- protection type: IP 54
- max. test pressure 25 bar
- test pressure: 0 to 25 bar in steps of 0.1 bar
- safety: safety valve
- delivery volume: 11 l/min. Maximum output approx. 300 l
   until automatic  switch off, limited by temperature.
- decompression: manual
- Geka connection for water connection
- quick coupling for pressure-side connectionVakumobil
Vakumobil for exhausting gas in cohesive grounds
- high-performance vacuum pump
- portable version
- high vacuum performance: max. 900 mbar
- maximum volume flow: 266 l/min.
- connection value: 230 V, 50 Hz, 5,5 A
- with 10 m suction hose DN 25
- with 2 m exhausting hose
- filter in transparent case

Test pump MPP 28-25
Test pump MPP 28-25 Pressure range 0 - 25 bar
- practice-oriented test pumps with electronic control unit 
  for the simplified performance of compression tests pursuant
  to EN 805 (W 400-2 in Germany)
- automatic pressure stabilisation for preset test pressure which 
  can be programmed in steps of 0.1 bar into the control unit
- high delivery capacity rate of 28 l/min enable the generation 
  of the required test pressure in less than 10 minutes, as required 
  by the contraction procedure

technical data:
- connection value: 230 V / 400 V   50 Hz
- power consumption: 2.200 VA
- protection type: IP 54
- max. test pressure 25 bar
- test pressure: 0 to 25 bar in steps of 0.1 bar
- safety: safety valve
- delivery volume: 28 l/min
- decompression: automatic / manual
- GSM-remote monitoring: optionalTest pump MPP 68-35
Test pump MPP 68-35 Pressure range 0 - 35 bar
- practice-oriented test pumps with electronic control unit 
  for the simplified performance of compression tests pursuant
  to EN 805 (W 400-2 in Germany)
- automatic pressure stabilisation for preset test pressure which 
  can be programmed in steps of 0.1 bar into the control unit
- high delivery capacity rate of 68 l/min enable the generation 
  of the required test pressure in less than 10 minutes, as required 
  by the contraction procedure

technical data:
- connection value: 400 V   50 Hz
- power consumption: 5.000 VA
- protection type: IP 54
- max. test pressure 35 bar
- test pressure: 0 to 35 bar in steps of 0.1 bar
- safety: safety valve
- delivery volume: 68 l/min
- decompression: automatic / manual
- GSM-remote monitoring: optionalTest pump MPP 68-25
Test pump MPP 68-25 Pressure range 0 - 25 bar
- practice-oriented test pumps with electronic control unit 
  for the simplified performance of compression tests pursuant
  to EN 805 (W 400-2 in Germany)
- automatic pressure stabilisation for preset test pressure which 
  can be programmed in steps of 0.1 bar into the control unit
- high delivery capacity rate of 68 l/min enable the generation 
  of the required test pressure in less than 10 minutes, as required 
  by the contraction procedure

technical data:
- connection value: 400 V   50 Hz
- power consumption: 4.000 VA
- protection type: IP 54
- max. test pressure 25 bar
- test pressure: 0 to 25 bar in steps of 0.1 bar
- safety: safety valve
- delivery volume: 68 l/min
- decompression: automatic / manual
- GSM-remote monitoring: optionalCompact Compressor CC 60
Compressor KK 60 for Pressure-Tests on house connections for gas/water 
Oil-free, operationally safe compressor for pressurization of gas and water pipes
Technical specifications
Type: piston compressor, 2 integrated fans for engine and cylinder
Power supply: 230 volts, 50 Hz, P = 505 W,
Air flow: > 60 l / min, and> 40 l / min at 3 bar
Pressure reducer: adjustable output pressure 0.5 bar to 10 bar
Operating temperature: - 10 ° C to + 45 ° C
Dimension: width 30 cm, depth 22 cm, height 22 cm
Weight: 10 kgPressure balloon with T-fitting
- for test of safty shut-off-valve
- with fine regulating valvePressure balloon for safety valve test
with fine regulating valve, coupling serie 20 Connection via connecting hose GT delta usability for GasTest delta 2006 or connecting hose GasTest delta3.Hand pump, aluminium
Rugged pump system with nipple S 20 for easily pressure rise up to max. 2 bar.
For easily handling at tightness and stress tests.Hand pressure ball T-piece
with fine adjustment valve and anti-kink springs
Vacuum backpack VSS 15
Mobile vacuum suction system for extremely sensitive gas detection.
Article comprises carrying system / backpack with vacuum technology and a rechargeable battery pack. 
Additional accessories (handpiece, probes, hoses, charger, etc.) are required and must be ordered separately. Minimum equipment is as follows:
- Carrying system / backpack (412010)
- Handpiece (412024)
- Bell probe (412025)
- Handpiece connection hose (412029)
- Measuring device connection hose (412031)
- Charger (412050)Manual compressor
Sturdy pump system with big handle and approx. 290 ml stroke volume for easy application of test pressures up to 10 bar.
Foldable footrests and robust metal body with quick coupling and shock-protected pressure manometer ( 0 ... 10 bar).Pressure balloon type EWE 
with fine regulating valve, both-sided nipple
Pressure balloon ZPA
with fine regulating valve, nipple serie 21Hand pump DruckTest 2000 NL Ver.1 & Ver.2
ready mounted
Hand pressure ball for calibration cap
Hand pressure ball for calibration cap of Esders Single & Multi Gas 
for manual aspiration of gas samples entries per page 
20
 1 - 18 / 18 
Pumps & Compressors

Test pump MPP 70-35

Test pump MPP 30-30

Test pump MPP 11

Vakumobil

Test pump MPP 28-25

Test pump MPP 68-35

Test pump MPP 68-25

Compact Compressor CC 60

Pressure balloon with T-fitting

Pressure balloon for safety valve test

Hand pump, aluminium

Hand pressure ball T-piece with fine adjustment valve and anti-kink springs

Vacuum backpack VSS 15

Manual compressor

Pressure balloon type EWE with fine regulating valve, both-sided nipple

Pressure balloon ZPA

Hand pump DruckTest 2000 NL Ver.1 & Ver.2 ready mounted

Hand pressure ball for calibration cap
